APC INROOM ACPSC3000 Provozní pokyny stáhnout pdf (Strana 12)

InRoom Controller - Operating Instructions12

AIN 9

AIN 8

AIN 7

AIN 6

1 10 21 30

11 20 31 40

Jumper designation

Analogous

input

AIN 6 101 102 103 104 100

AIN 7 201 202 203 204 200

AIN 8 301 302 303 304 300

AIN 9 401 402 403 404 400

Connected sen-

sor type at anal.

input

0-10V 1-2 2-3 1-2 1-2 0

4-20mA 1-2 1-2 1-2 1-2 0

PT100 2-3 0 2-3 2-3 1-2

PT1000 2-3 0 2-3 2-3 2-3

corresp. Jumper 101-404

input (enlarged section)

Jumper 100-400

(enlarged section)

Table: Jumper setting

The EAIO-board is an extension board for analogous

inputs and outputs. It can be attached to the I/O

controller board at any of the four sockets and will

be recognized by the IOC due to a self test.

There are several jumpers on board - ﬁve for each

input - which serve to adapt the board to different

sensor types.

How to use the Jumper setting table:

- Choose the analogous input at which you have

connected a sensor.

- In the same line you can see the jumpers which

relate to this input.

- In the lower part of the table you can read in

each column the jumper setting depending on

the sensor type you connected.

Example:

You have connected a PT100 at AIN 8. The

corresponding jumpers are 301-304, 300. Jumper

301,303,304 must be set on position 2-3, Jumper

300 on 1-2 and Jumper 302 not at all.

Pin position

2.3 EAIO - Extension board for analogous in- and outputs

2.3.1 Board design

Technical Data:

Power consumption: 10.1 VA

Operating temp.: 5°C...40°C

Storage temp.: -30°C...60°C

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 105 106

Komentáře k této Příručce

Žádné komentáře

APC INROOM ACPSC3000 Provozní pokyny Strana 12

Komentáře k této Příručce