APC NetBotz 200 Uživatelská příručka stáhnout pdf (Strana 33)

USER’S GUIDE

NetBotz Rack Monitor 200

Perform the following steps until the alarm is cleared:

If you intentionally disconnected a sensor, module, or beacon, you

can clear the Sensor Disconnected alarm from the Administration >

General > Reset/Reboot page. From the Overview page or the Alarm

Status page, perform the following:

1. Click the Reset Alarms

link to go to the Reset/Reboot page.

2. Select

Reset Only.

3. Select the

Lost Communication Alarms checkbox.

4. Click

Apply.

This procedure requires you to troubleshoot your setup on-site

while monitoring the Web interface or control console. See the

NetBotz Rack Monitor 200 Installation and Quick Configuration

Manual for local access to the control console, if needed, and for

system setup details. The NetBotz Rack Monitor 200 Installation

and Quick Configuration Manual was provided with your Rack

Monitor 200 and is also available on the APC Web site,

www.apc.com.

For additional assistance or if performing these steps does not

resolve the problem, contact APC Worldwide Customer Support.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 124 125

Žádné komentáře

APC NetBotz 200 Uživatelská příručka Strana 33