APC Network Management Card AP9617 Uživatelská příručka stáhnout pdf (Strana 59)

®®

USER’S GUIDE

network management card

Syslog Server Settings

Server IP Uses specific IP addresses to Identify which of up to four servers will

receive Syslog messages sent by the Management Card.

OTE: To use the Syslog feature, at least Server IP must be defined

for at least one server.

Port Identifies the user datagram protocol (UDP) port that the Management

Card will use to send Syslog messages. The default is 514, the

number of the UDP port assigned to Syslog.

Local Priority (Severity Mapping)

Map to

Syslog’s

Priorities

Maps each of the severity levels (Local Priority settings) that can be

assigned to UPS, environmental monitor, and Management Card

events to the available Syslog priorities. The following definitions are

from RFC3164:

• Emergency: The system is unusable

• Alert: Action must be taken immediately

• Critical: Critical conditions

• Error: Error conditions

• Warning: Warning conditions

• Notice: Normal but significant conditions

• Informational: Informational messages

• Debug: Debug-level messages

Following are the default settings for the four Local Priority settings:

• Severe is mapped to Critical

• Warning is mapped to Warning

• Informational is mapped to Info

• None (for events that have no severity level assigned) is mapped to

Info

OTE: To disable sending Syslog messages for Severe, Warning, or

Informational events, see Event Actions (Web Interface Only).

Setting Definition

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 189 190

Žádné komentáře

APC Network Management Card AP9617 Uživatelská příručka Strana 59