Apc UPS control system Uživatelský manuál stáhnout pdf (Strana 103)

want to send an email message to root. At present the arguments that

apccontrol recognizes are:

When apcupsd detects an event, it calls the apccontrol script with four

arguments as:

apccontrol <event> <ups-name> <connected> <powered>

where:

event is the event that occurred and it may be any one of the values

described in the next section.

ups-name is the name of the UPS as speciﬁed in the conﬁguration ﬁle

(not the name in the EEPROM). For version 3.8.2, this is always set

to Default

connected is 1 if apcupsd is connected to the UPS via a serial port (or a

USB port). In most conﬁgurations, this will be the case. In the case of

a Slave machine where apcupsd is not directly connected to the UPS,

this value will be 0.

powered is 1 if the computer on which apcupsd is running is powered by

the UPS and 0 if not. At the moment, this value is unimplemented

and always 0.

apccontrol Command Line Options

apccontrol accepts the following command line options:

annoyme When a shutdown is scheduled, and the time speciﬁed on the

ANNOYME directive in the apcupsd.conf ﬁle expires, this event is

generated.

Default — does a printf ‘‘Power problems please logoff.’’ |

wall then exits.

changeme When apcupsd detects that the mains are on, but the battery is

not functioning correctly, this event is generated. It is repeated every

x hours.

Default — does a printf ‘‘Emergency! UPS batteries have

failed\nChange them NOW’’ | wall then exits.

102

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 232 233

Žádné komentáře

Apc UPS control system Uživatelský manuál Strana 103