APC AP9612TH Datový list stáhnout pdf (Strana 8)

4 Environmental Monitoring Card

Installation

How to connect

the card

1. Connect the supplied probe to probe connector 1 on the

card. Place the probe using the supplied hook and loop

fasteners, if needed.

2. To use contact monitoring, connect contact sensors to the

removable screw terminal block. (See “Sensor Zone

Connections” on page 6). The contact monitoring

connection is a two-piece design. Strip 0.25" (6 mm) of

the wire insulation . The connector accepts wire sizes

from 14 AWG (1.6 mm²) to 26 AWG (0.4 mm²).

3. Connect the screw terminal block to the sensor zones

connector of the card. The figure below shows Zones 1

and 2 in use and Zones 3 and 4 open.

Note

Use the probe on a flat surface in a protected area

with adequate air flow and minimal dust. Do not

operate the probe where temperature and humidity

are outside the limits specified on page 10.

Warn

Do not cover the ventilation holes on the

probe.

Do not immerse the probe or place it where

dew can form.

Do not use the probe in an environment with

chlorine gas or insecticides.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Žádné komentáře

APC AP9612TH Datový list Strana 8