APC NBRK0550 Instalační příručka stáhnout pdf (Strana 10)

NetBotz Wireless Temperature Sensor Installation Guide

Adding the Wireless Temperature Sensor to the

Network

Overview

The order in which you power and configure your wireless network is

important.

For best results, power and configure the Coordinator, and any Routers, on your

wireless network before adding the Wireless Temperature Sensor.

Add the Coordinator and Routers to the NetBotz Advanced View.

Add the extended addresses (MAC) of the Coordinator and Routers to the “Add

Addresses” dialog, accessed from the Wireless Sensor Setup task in the

Advanced View.

For information about configuring your wireless sensor network, see the

installation manual that came with the NetBotz Wireless Sensor Pod 180 or the

NetBotz Wireless USB Coordinator & Router.

Add the address of the Wireless Temperature Sensor. You can use a

hand-held USB QR code scanner with document capture capabilities to scan the

extended address (MAC) of the Wireless Temperature Sensor directly into the

“Add Addresses” dialog, accessed from the Wireless Sensor Setup task in the

Advanced View.

Alternatively, you can use any QR code scanner to save a list of MAC addresses

to a text file, one address per line, and copy and paste it into the dialog, or enter

the addresses manually.

Some QR code scanners return the part number, serial number, and MAC

address on one line:

XN:NBWS100T%SN:XXXXXX123456%MAC:00C0B70000XXXXXX.

To add a sensor to your wireless network, enter only the alphanumeric MAC

address of each sensor in the “Add Addresses” dialog in the Advanced View.

Once the addresses have been added to the list, you must click Apply

Commission List to save the list to the NetBotz appliance.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Žádné komentáře

APC NBRK0550 Instalační příručka Strana 10