APC AP9613 Instalační manuál stáhnout pdf (Strana 12)

Installation Manual

The UPS Network Management Card (NMC) is sensitive to static

electricity. When handling the NMC, touch only the end plate while

using one or more of these electrostatic-discharge devices (ESDs):

wrist straps, heel straps, toe straps, or conductive shoes.

If a cable is connected to the serial port at the UPS or chassis, stop the APC service

that uses that serial connection, and disconnect the cable.

1. If you are installing a chassis, connect the chassis to the UPS serial port.

2. Use the same screws that hold the expansion slot cover in place to secure

the NMC in the chassis slot.

3. Connect a network interface cable to the 10/100Base-T network connector

on the front panel of the NMC.

4. If you are using the AC Adapter (AP9505), connect the adapter to the

chassis. Then connect the adapter to an independent AC input so that the

NMC can continue to operate if the UPS is turned off or not operating.

5. If you disconnected a cable in step 1, reconnect that cable to the serial port

at the chassis, and restart the associated APC service.

6. See “Quick Configuration” on page 9.

mph0459a

DMP IM 990-3404.book Page 8 Monday, March 11, 2013 9:05 AM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Žádné komentáře

APC AP9613 Instalační manuál Strana 12