APC AR1100 Návod k obsluze stáhnout pdf (Strana 4)

Use precautions

Before Use

CAUTION

• Do not use the device for other than the intended purpose.

NIDEK is not responsible for accidents or malfunctions caused by misuse.

• Be sure to read the manual prior to operation of the device to understand the safety

precautions and operating procedures thoroughly.

Using the device for purposes other than specified in this manual may cause unex-

pected malfunctions and/or adverse events.

• Never modify nor touch the internal structure of the device.

Electric shock or malfunction may result.

• Install the device in an environment that meets the following conditions. The following

conditions must be maintained during use.

Use conditions

Temperature: +10 to +35

°C

Humidity: 30 to 75% (Non-condensing)

Pressure: 800 to 1060 hPa

A dust-free location

A place with little external light

A level and stable surface free from vibration and shock

If the device is not installed and used under the above conditions, the reliability of mea-

sured results is impaired, and malfunction may result. In addition, there is a possibility of

injury if the device receives shock and falls down.

• Install the device in an environment where no contaminants such as corrosive gas,

acid, and salt are contained in the air.

Corrosion or malfunction of the device may result.

• Avoid installing the device where it is exposed to direct air-conditioning flow.

Changes in temperature may result in condensation inside the device or adversely

affect measurements.

• Be sure to use a wall outlet which meets the power specification requirements.

If the line voltage is too high or too low, the device may not perform properly. Malfunc-

tion or fire may occur.

• Connect the power plug to a ground outlet. Or connect a grounding wire to a ground

terminal.

Electric shock or fire may occur in the event of device malfunction or power leakage.

• Completely insert the power plug into the outlet as far as the prongs will go.

Fire may occur if the device is used with a loose connection.

• Never use a table tap or extension cable to supply the device with power.

The electrical safety may be lowered.

1 2 3 4 5 6 7 8 9 ... 143 144

Žádné komentáře

APC AR1100 Návod k obsluze Strana 4